|
Post by melx5 on Mar 6, 2019 17:41:31 GMT
Did my water pump and belts a couple of days ago and now have a leak where the hard return pipe fits into the flange (?) bolted to the pump
After fitting the pump I seated the pipe only to find I had to pull it slightly to line up with the bolt holes in the side of the pump, not sure if this is why it failed to seal or not.
Anyone else have the same issue ?
|
|
|
Post by melx5 on Mar 7, 2019 12:06:17 GMT
Sorted, turns out all I needed to do was re seat the o.ring and lift the pipe to get the bolts to align, was frozen stiff and rushing to finish the other day.
Why can't things break on warm sunny days.
|
|