Post by melx5 on Nov 5, 2017 8:15:04 GMT
I want a stainless/alloy flange to fit around my rear roll bar to cover the hole where it goes through the carpet, the problem is the bar isn't vertical so in order for it to look tidy it will need to be oval, this is where my problem starts
When I drew the tubing to scale the difference in diameter of the hole was approximately 10mm front to back vs side to side, I know I will need some clearance for it to fit but I don't want 6/7mm on either side.
Further complication is caused by the flange needing to be in two halves (to fit) and to complicate things further I want four with two at 90 degrees to the lower to make sure it sits flat on the parcel shelf.
I use a free online 2d drawing package and even though I can draw the flanges it won't allow me to put the dimension of the oval on.
Any ideas?
When I drew the tubing to scale the difference in diameter of the hole was approximately 10mm front to back vs side to side, I know I will need some clearance for it to fit but I don't want 6/7mm on either side.
Further complication is caused by the flange needing to be in two halves (to fit) and to complicate things further I want four with two at 90 degrees to the lower to make sure it sits flat on the parcel shelf.
I use a free online 2d drawing package and even though I can draw the flanges it won't allow me to put the dimension of the oval on.
Any ideas?
le sigh